|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
wet base gasket
I just got my 200 back together added coolant and after about 3 hours of sitting i noticed that the base gasket in the ignition side towards the front of the bike was lightly damp, not dripping any coolant is this normal to happen after adding the coolant? i torqued all the base bolts to the right spec. I did not use any sealant on the gasket, just put it on dry.
__________________
Jack - western PA 2006 KTM 250 sx 2006 EC 200/ 11' style kit--GONE 2004 200 EXC 1997 KDX 220 2004 CRF 250X 1974 CL125 www.youtube.com/allthatstuff35 <---some gasgas videos here |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Base Gasket re-use? | motogroove | Enduro Engine - 2 stroke | 5 | 06-26-2011 07:56 PM |
!!! Help with Base gasket thickness !!! | timlh | Enduro Engine - 2 stroke | 1 | 05-14-2009 07:58 PM |
Base gasket | Ud_luz | Enduro Engine - 2 stroke | 21 | 05-09-2008 07:38 AM |
Base gasket preparation? | d2w | Enduro Engine - 2 stroke | 7 | 06-25-2007 06:30 AM |
Base Gasket | gtsnowcrack | Enduro Engine - 2 stroke | 6 | 09-09-2006 05:43 AM |