|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Shift Lever
|
#2
|
|||
|
|||
Yes great lever better then the standard lever had to die grind the tip a little to stop it rubing on the case but is a good product thanks andrew
__________________
|
#3
|
||||
|
||||
i was looking at this one also - thanks - seller said it's the same dimensions as stock - is it?
|
#4
|
||||
|
||||
Hammerhead
I almost went with the one you posted, but went with a Hamerhead because I wanted a longer offset to fit my boot. The tips are also replaceable so you don't have to buy a whole new lever.
http://www.hdmoto.com/ProductDetails...ctCode=GGTMSLR I wouldn't reccomend the rubber tip, it wears out pretty fast.
__________________
Howie 2008 KTM 530 Former Fantasies: 2007 KTM 525 2004 Honda CR250R 2011 Gas-Gas EC 300 2009 KTM 300 XC-W 2004 KDX 200 2000 KDX 220 2003 Gas-Gas EC 250 2004 Honda CRF 250X 2005 Honda CRF 250X What can I say, I'm schizophrenic and ambidextrous! |
#5
|
||||
|
||||
i received the tmv one. it's about 15mm longer and sticks outboard about 15mm more than the stock one.. definitely way better than the original one.
|
#6
|
|||
|
|||
brake lever
Did these folks have a Gas Gas specific spline?
|
#7
|
||||
|
||||
not sure what else the spline fits, but the tmv are splined perfectly to fit gas gas. no issues..
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shift lever crossover | moto9 | General Discussions & Announcements | 12 | 04-05-2010 12:13 PM |
Longer shift lever for the FSE??? | McGuiver | Enduro Engine 4 stroke (including EFI & Exhaust) | 7 | 01-08-2009 08:04 PM |