|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Basic clutch question
Just got done rewiring my 04 ec 200 and now I have a really nice running gas gas. However when I took my clutch slave cylinder apart part of the housing was messed up and I don't think it will work. It was where the prints would rest on the inside, there was a decent part where in inner position had rubbed on the bore. Anyway, where do I get another one? Is there any other bikes that used the same slave cylinder?
|
#2
|
|||
|
|||
Quote:
Not sure if they carry complete replacement slave cylinders, you may have to try and order through a dealer if the rebuild kit will not work. I would contact AJP first. |
#3
|
||||
|
||||
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2012 300 racing basic jetting | britishgas | Enduro Intake/Carburetion - 2 stroke | 3 | 10-23-2013 01:39 PM |
clutch question | Rabbitist | Enduro Engine - 2 stroke | 0 | 02-27-2012 08:23 PM |
2001 EC 300 200lbs rider Basic settings for New England H/S and Enduros | wavemanz | Enduro Suspension | 3 | 07-13-2010 08:04 PM |
Gas Gas EC 300 09 Basic Suspension Settings | snaissidis | Enduro Suspension | 0 | 03-16-2009 04:05 PM |
Basic Settings for 2005 DE250 | the eel | Enduro Suspension | 1 | 09-02-2006 12:37 PM |