|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#29
07-23-2018, 08:14 PM
|
||||
|
||||
Just to report back. Vibration seems about the same; ie minimal on the new crank using Woosner rod and piston.
Am getting some hanging idle issues but sprayed some brake clean around everywhere and it doesn't affect idle. Then as I cleaned the copious mud from crazy muddy ride I noticed that the fuel line was kinked pretty bad so may have been starvation. Or the new carb I just put on.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crank bearing failure .WTF ? | Getoviq95 | Enduro Engine - 2 stroke | 2 | 04-16-2017 01:27 AM |
| gas gas stator failure ? | klex | Enduro Engine 4 stroke (including EFI & Exhaust) | 2 | 08-24-2016 12:29 AM |
| Ignition side crank bearing failure? | wence | Enduro Engine - 2 stroke | 37 | 06-16-2016 07:21 PM |
| Rebuild failure | Capz85 | Enduro Engine - 2 stroke | 44 | 04-15-2016 12:24 PM |
| Crank Remover and Crank Installer tools for EC250 | Fabry | Enduro Engine - 2 stroke | 5 | 06-25-2013 07:24 PM |
Threaded Mode