|
Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
No oil pressure when doing wheelies
I´ve got a 450 SM -06 and I have discovered a terrible problem. It doesn´t take many seconds on the rear wheel before the oil light comes on.
How do you do? Just keep the the front wheel down or has anyone of you a good solution? I´ve thought about the oil level, should I dare to fill up a little more oil if it matters or will it just damage the engine? Don´t wanna do any bigger surgery right now, but I might have to? Because you can´t have a motard that don´t wanna wheelie! |
#2
|
|||
|
|||
i would think there would've been some usefull reply to your problem,but nothing sofar
it's true, you can't not wheelie with a motard...it's one of the most fun things to do anyway,hope you get a solution soon to this problem. maybe fill the oil to a litlle higher level. ciao, hannes. Last edited by hannesd; 08-18-2010 at 03:52 AM. |
#3
|
||||
|
||||
I have the 06 enduro. Doesn't like extreme hills and flashes the oil light, especially if a little low. I overfill a little to minimise the problem. I assume the 05 is fine with the dry sump. It may be that other bikes do this as a many enduros don't have oil lights.
|
#4
|
|||
|
|||
i have an 07 and it does the same thing. i fill it to the top of the top sight window which is about 850mls. the manual says it takes 1200mls when changing filter ,but i always thought a sight window was supposed to be in the middle . anybody try to put 1200mls in? if so, whats the result?
|
#5
|
|||
|
|||
I don't know about the SM but if you search around for info on the Moto Guzzi V11 oil sump, it had the same problem under hard acceleration. They solution was to put a baffle in the middle of the sump so that the oil wouldn't slide all the way to the back and will keep the oil pressure up.
|
#6
|
|||
|
|||
Quote:
|
#7
|
||||
|
||||
Quote:
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#8
|
||||
|
||||
Fastisbetter, your 07 should have 2 sight glass windows, of which the level is supposed to be between the two.
__________________
Dont follow me, You wont make it. |
#9
|
|||
|
|||
well thats good to know, what are the sight glasses for?
|
#10
|
|||
|
|||
sorry, just read your post Nick. 900mls puts it over the top window
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC 300 cylinder pressure | pevs | Enduro Engine - 2 stroke | 33 | 05-30-2023 01:58 PM |
400 FSE Fuel Pressure | Gi_GASGAS | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 04-24-2010 02:06 AM |
Minimum tyre pressure | stay_upright | Enduro Chassis & Body | 13 | 07-22-2009 10:47 AM |
How much fluid and pressure and sag? | gasser | Enduro Suspension | 0 | 04-16-2009 02:16 PM |
Higher pressure radiator caps | Skidad | Enduro Engine - 2 stroke | 5 | 11-03-2008 03:26 PM |