EC 250 Spark plug

[Grampy]

The manual that came with my Gas Gas 250EC calls for a NGK BR8EG which is a resistor plug. The NGK book at my dealership calls for a B8EG non resistor plug. Any problem with running a non resistor plug? Have heard concerns about non resistor plugs harming CDI units.

Thanks

[widebear]

Just put in a resistor plug. Their main purpose is to cut down on rf noise that can interfere with radio and other forms of communication and sensitive electronic transmissions and data aquasision.

[MattR]

Like widebear mentioned, use a resistor plug. I have used both BR8EG and BR8ES plugs. The G plug has a fine wire nickel alloy electrode, the S plug has a standard 2.5mm electrode.

[Grampy]

Originally Posted by MattR

Like widebear mentioned, use a resistor plug. I have used both BR8EG and BR8ES plugs. The G plug has a fine wire nickel alloy electrode, the S plug has a standard 2.5mm electrode.

Which worked better, the BR8EG or the BR8ES?

[roostafish]

I fouled a plug once at high elevation and put in a B8ES which I had as a spare. I forgot about it, and ran it for about a year before I did the squish band mod on my head and found it. I laughed at myself as I took it out.

My experience is that it doesn't matter a bit which plug you run. The expensive electrode is a waste of money. I would still choose a resistor just in case there were interference issues, but I certainly didn't have any with the non resistor plug.

[MattR]

Originally Posted by Grampy

Which worked better, the BR8EG or the BR8ES?

I had same results as roostafish. I could not tell a difference between EG vs. ES. It probably depends on how well your jetting is dialed-in. I found BR8ES easier to find so I just run those in my bike.

FYI... there is also an iridium plug that may be interesting to try out. In my Husky SM610, this plug is a well known trick to eliminating some rich hesistation at 4000 rpms. The iridium plugs are pricey at $10 each. The iridium plugs provide a stronger, more consistent spark for a cleaner burn.

Here is more info:
http://www.ngksparkplugs.com/product...x.asp?mode=nml

I usually replace my spark plug yearly for piece of mind. So I will probably throw one of the iridium plugs in to try out. The GasGas EC250 would use a BR8EIX iridium plug (where IX is the callout instead of EG or ES).

[2 strokes 4 life]

I highly recomend a BR8EIX. Its a great pulg and wont foul. I was running a 185M jet, 48 pilot, and AS 1 turn out durring break in and then swapped out to a 175M, 42 pilot, and 1.5 turns out. Saying the least I was running rich and it still never fouled. Best under $10 spent ever.