|
|
|||||||
| Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
|
Thread Tools | Display Modes |
|
#1
09-09-2016, 02:32 AM
|
||||
|
||||
Fuse Block
When I removed the 10a fuses from my 12' 300 they were fairly tough to remove and one was brittle and maybe broken, not blown.
When I put new ones in I tried to push them in as hard as I could, but they didn't seem to seat real well and only seem to be held in by the plastic caps. Do I need to try harder to jam them in for a more solid connection? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FSE 400 2002 Fuse values | outland75 | Enduro Electrical & Wiring | 1 | 02-27-2016 03:17 AM |
| fuse location | Mark b | Enduro Electrical & Wiring | 1 | 02-27-2016 03:13 AM |
| Fuel Pump Fuse (A8) on GG450 blowing | Crankin04 | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 08-30-2010 11:41 AM |
| Ken Block...at it Again! | Rick | Pictures & Videos | 5 | 11-06-2009 12:56 PM |
| Where's The Lighting System Fuse?!!! | JGress | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 05-21-2008 08:24 AM |
Threaded Mode