![]() |
|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
![]() |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
![]()
Hopefully this will save some one many hours of frustration.
Fault :- Intermittent spark, sometimes no spark at all (once died while idling on stand) sometimes ran good up to half revs and then bogged, hard to start and then back fired when it felt like it. After doing reeds, rings, crank case seals, wiring loom, changing stator coil,CDI,HT coil all it needed was a 5 sec spray of contact cleaner in the loom and CDI connecting plug.....all faults gone ![]() This is the first time my 05 300 has ever given trouble, if there is a next time I would like a easy fault! ![]() ![]() |
#2
|
||||
|
||||
![]()
Thanks for the heads up got that noted its bound to happen sooner or later.
__________________
1998 EC250 07 Shivers 2T racing PV Spacer FMF Gnarly |
#3
|
||||
|
||||
![]()
I had the same problem on my 07' 125, I went over everything many times, pulled the carb about 4 times, was just about to take it too the shop to get them to diagnose, but the fix was just that one of the female connectors was too loose, squashed it and the fit was much better, and never had a problem with that since.
|
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Another no spark question... | egesledder | Enduro Electrical & Wiring | 1 | 08-20-2010 07:27 AM |
no spark... | stainlesscycle | Enduro Electrical & Wiring | 9 | 02-17-2010 08:06 PM |
EC 250 Spark plug | Grampy | Enduro Engine - 2 stroke | 11 | 12-16-2008 01:24 AM |
weak spark | tallboy350 | Enduro Electrical & Wiring | 5 | 11-24-2008 09:18 PM |
End cap with spark arrestor | Qui-gon | General Discussions & Announcements | 3 | 05-08-2008 05:41 PM |