|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
shift problems..
so, before i split the cases, it appears something is wrong with the trans on this 300 motor. it was shifting ok, and now it will only shift into 1st and neutral. i pulled the clutch, and try to manually turn the shift drum. no go. only 1st and neutral. i'm guessing a bent shift fork/bad shift barrell/something in there is bound up. any suggestions?
anyone have a good bottom end with crank/rod/trans that shifts fine? i dont need clutch/ignition/etc. it may be less expensive to buy a bottom end than replace parts.....
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com Last edited by stainlesscycle; 05-10-2010 at 12:49 PM. |
#2
|
|||
|
|||
i have a complete lowerend for a wild 300 quad, it needs a crank rebuild but the trans shifts fine and the clutch assy is good it also has a magneisum stator cover and i believe it has a higher output lighting coil you can have the complete lowerend, all the electrics and the hydraulic clutch set up for 250.00 PM me if your intrested
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shift shaft problems- continued | Trailrider | Enduro Engine - 2 stroke | 10 | 03-17-2010 12:34 PM |
shift under load | fullthrottle | Enduro Engine - 2 stroke | 4 | 09-25-2008 09:38 PM |
Shift spring | sprocket74 | Enduro Engine - 2 stroke | 0 | 05-19-2008 09:12 PM |