|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Installing S3 FWW on ec300 race
So, while checking everything over on my 2012 EC300 race that I just purchased, I removed the S3 660 gram FWW and flywheel to get a look at the stator. All looks fine and clean in there and there's no leaking crank seal. However, I'm starting to question myself about re-installing the weight. Is there a particular way it goes on in relation to the flywheel? Like, timing marks or something similar just to keep it balanced? Or can I just bolt it back on without having to worry about balance issues and/or the orientation of both the flywheel and the weight? Any help is greatly appreciated. Thanx.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Installing Rekluse tonight.... have some questions. | fst96se | Enduro Engine - 2 stroke | 9 | 08-27-2014 08:10 PM |
Installing Vapor on EC300? | binsel | Enduro Other... | 10 | 09-15-2011 08:21 AM |
Help on installing kick start gears | asshat | Enduro Engine - 2 stroke | 0 | 09-15-2008 04:53 PM |
Installing new Air Filters | warnzie | Enduro Intake/Carburetion - 2 stroke | 7 | 11-27-2007 07:10 AM |