Rieju & GasGas Legacy Riders Club Forum

Page 2 of 2

Show 40 post(s) from this thread on one page

Rieju & GasGas Legacy Riders Club Forum (http://www.gasgasrider.org/forum/index.php)

- Enduro Suspension (http://www.gasgasrider.org/forum/forumdisplay.php?f=16)

- - fork changeover (http://www.gasgasrider.org/forum/showthread.php?t=24308)

Hooligan

11-03-2019 11:04 PM

Quote:

Originally Posted by (F5) (Post 188987)

Mate has just done with YZF450 forks and it is good when travel is being used but too 'everything' most of the rest of the time.

I am contemplating swapping a set of YZ KYBs into my 2010 EC250. Any ideas if the YZ steering stem is compatible with the GasGas steering head? I'd assume at least a bearing swap will be required.

Anders

11-04-2019 03:38 AM

Quote:

Originally Posted by Hooligan (Post 192703)

I am contemplating swapping a set of YZ KYBs into my 2010 EC250. Any ideas if the YZ steering stem is compatible with the GasGas steering head? I'd assume at least a bearing swap will be required.

This question is covered here

swazi_matt

11-04-2019 01:46 PM

what i did with mine was got a second top t-clamp and had it machined out by a mm or 2.
I also retained the GG wheel by getting special spacers made to accept the yz axle

I believe all balls has a bearing conversion kit if you want to use a full yz front end

Elvis74

11-05-2019 12:10 AM

I have a 2006 KYB SSS fork in the original gasgas tripple clamps. I machines them as well. I put the original gasgas wheel with special made spacers in fits without problems

Gesendet von iPhone mit Tapatalk

All times are GMT -5. The time now is 01:19 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page