Wild hp 300 sprocket Carrier interchange
Wondering if anyone has any info on if there is any other quads that share the same size/spline on the axle for the sprocket carrier, I know the banshee is also a 25 spline but not sure if it is the same diameter shaft. If anyone can share any info it would be greatly appreciated!
|
possibly one of the Honda models. trx250r/400ex/trx450r
|
i am looking for a gasgas 300 pipe. know where i can find one?
|
TRX450R axle swap in wild hp 300
After months of searching the internet for rear brake parts, sprocket carrier and different sprocket sizes with no luck I noticed the TRX450R takes the same axle bearing, lucky for me I have a 2004 trx, so I started doing some measuring and decided to disassemble both quads and see if the trx axle and components would fit. What I determined is everything fit right on even the caliper mount. The only thing I had to do was grind about 1/8?-3/16? off the outside of the brake disk carrier.
|
I recently talked to one of the fellas at Durablue about an axle on my wild 300.
The axle itself was based on a Honda trx400ex unit. Of coarse some dimensions were changed but its a good starting point to figure out interchanges. |
All times are GMT -5. The time now is 09:21 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org