kill switch???
 

the kill switch on the 300 never work since I got the bike its the run type switch ud see on a road bike on and off.but the bike ran fine with the switch in on and off position..so I bought a new kill button the mx type.. so I went about fitting the new one..first I cut the two wires going to the old switch and crossed/joined them to see if it would kill the engine and it did not ..so I traced the two wires back to the ecu and there is another joint just before the ecu so I crossed and uncrossed um there and it still didn't kill the engine..so what do I do now?? I tried put the new swicht straight onto one of the wires going into the coil but the engine will only run with the button pressed so id need a normally closed switch for that method..so do I go and buy a on/off type switch and wire it to the coil. .. any suggestions????

The switch was you map switch, it should be left as a on/off switch. seems as though your kill switch was completely missing

so im getting no where with this switch so I need more help...this is what I have..Attachment 4431old switchAttachment 4432new swichtAttachment 4433two wires going to the old switchAttachment 4434same two wires going to the cdi, joint in two wires

That old switch is not a kill switch. That is your map switch (ignition curves). The black and green wires are the two you want for the kill switch.

Attachment 4436 I also found this yellow wire doing nothing just taped up with insolation tape
Attachment 4437coil

the black and green were the wires going to the old switch I just cut um off the old switch then I joined um as a test to see if it would cut the engine with no success then I tried putting the black and green onto the new swicht notting happened that time either with button pressed/not pressed

so I need to get another on/off (map) type switch and the kill switch wont do unless I wire it straight to the coil..then why is the bike running without the map switch and still running when I cross the two wires going to the map switch even tried touching um off the frame to earth them..

Sent from my GT-I9300 using Tapatalk

What year is your bike? Let me look up the wiring diagram later this afternoon so I am sure I am not offering bad advice...

o7 ec 300

Sent from my GT-I9300 using Tapatalk

https://db.tt/XtuuHWQf an idea of what im working with

Sent from my GT-I9300 using Tapatalk