Turn signals
 

I purchased LED turn signals but need to know how to wire them into my 03 GGec300?????? Any and all help would be appreciated!!!!

Thanks
Lee,

You may want to read the AD/DC sticky.
http://www.gasgasrider.org/forum/showthread.php?t=7900
And the how to go DC thread.
http://www.gasgasrider.org/forum/showthread.php?t=1859
Some info there.
As far as I understand you need DC power to properly run LEDs.
I did the floating ground conversion and run DC with a small sealed
lead acid battery on my '02 XC/EC300.
I suppose you could wire a dedicated / isolated, constant loss DC system
to just run the turn signals. Use a small 4-5Ah battery and charge it at
home before you use the bike. Might be more trouble than doing it right.
To make my conversion way easier I bought a used Full EC wiring harness
from a forum member from Canada to replace the XC harness from my bike.
Happy hunting and good luck.
Jeff