premix
Was filling the bike up today with the jerry can that i had full of fuel (5L) was putting my silkolene premix stuff into it when my mate said hang on :confused:
My mate said im doing it all wrong im premixing to much with the 5L fuel i was putting in 5L fuel + 100ML silkolene premix, Correct? I was also told this was the correct level of mixing from the guy i got the bike from. Could someone confirm that im correct? :) |
That would be 50 to 1 or 2% so you're doing it right.
|
gasser's spot on, heres a calculator you and your buds can use if needed.
http://www.csgnetwork.com/oilfuelcalc.html Ron |
Everyone run 50:1 here?
|
When I bought my LTR jet kit Les advised me to run 32:1. Against his advice I have ran 40:1 since the bike was new. Same in the kids bike.
|
I run 45:1. Used to run 40:1 which always left a small amount of spooge at the end of the silencer. 45:1 has always left my silencer clean.
|
Quote:
|
I run 38:1.
Why? More oil = better ring sealing and less wear. My 2 data points... Top ring end gap increased 0.006" in 91 hours at 50:1 Top ring end gap increased 0.001" in 49 hours at 38:1 This data was with AmsOil Interceptor. Your mileage may vary. |
Quote:
|
Quote:
http://www.gasgasrider.org/forum/showthread.php?t=182 It lists the amount of gas in first columns, then the amount of oil in the last columns. 5 liters is approx. 1.25 gallons... so 100 milliliters is right as mentioned previously. The link above gives premix for a variety of ratios. |
All times are GMT -5. The time now is 04:43 PM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org