|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Linkage - where do my washers live!
I'm mid way through servicing my linkages and despite being very careful, these two washers dropped out of "somewhere" while I was tapping away at the swing arm bolt
I've taken a photo of the offending washers against the linkage arms for reference They seem to logically (and physically) fit on either the upper or lower shock mounts but I'm not sure. Maybe on the lower shock mount where it bolts to the linkage, with the wider/inside part of the washer on the bearing race, and the outside part protecting the oring?? The only things that have been disassembled are what you see in this photo, plus the top shock mount on the frame. Any help or references to linkage diagrams is much appreciated. |
#2
|
||||
|
||||
Lower shock mount bolt
__________________
2011 EC300 Six Days 2010 EC300 Nambotin Replica |
#3
|
||||
|
||||
Yep! Lower shock mount. They cup out obviously. ( shock mount ) and clevis slides over the top.
|
#4
|
|||
|
|||
Thanks guys. I'll pay attention next time ;-)
|
#5
|
|||
|
|||
I've revived this thread because I always forget how my linkage goes back in.
Thanks for the photo. Linky thing forward, shocky thing in the back. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EnduroCross Live | twowheels | Pictures & Videos | 0 | 10-26-2013 12:16 AM |
Large flat washers in linkage?? | ckblum | Enduro Suspension | 5 | 08-20-2013 10:54 PM |
Check those linkage washers! | rgranger | Enduro Suspension | 4 | 07-07-2013 01:18 PM |
Linkage washers-do they really matter? | husley | General Discussions & Announcements | 14 | 03-09-2013 02:36 PM |
2 small "cup" washers in linkage? | r00zter | Enduro Suspension | 3 | 04-07-2012 12:58 AM |