|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#21
|
||||
|
||||
On fmf's faq the say that dents and dings close to the head have a larger (negative) impact on performance
|
#22
|
||||
|
||||
Does anyone know if P3 has gotten their act together? Last time I ordered a pipe guard or tired ordering a pipe guard from them I had to cancel after 8 months of no pipe guard and couldn't contact them or get any type of answer as to it's where abouts. I had to contact my credit card company to get my money back.
|
#23
|
||||
|
||||
Quote:
__________________
15 GASGAS EC 250 19 Sherco SE 125R |
#24
|
||||
|
||||
Quote:
Only comment is they don't have a guard that fits the 200 pipe, they have one for the 250/300s, but not current 200s (at least '11 and newer) - had to return my guard for a refund |
#25
|
|||
|
|||
Well, my sweet looking pipe guard didn't look sweet for very long.
Quote:
Here is the article I mentioned earlier http://motocrossactionmag.com/news/t...-catastrophies Sent from my iPhone using Tapatalk |
#26
|
||||
|
||||
Thanks OK my pipe is an FMF which is the same for the 200,250 and 300. I sent them an email and got a reply right away.
|
#27
|
||||
|
||||
Quote:
It'd be great if they had a gnarly pipe available for current 200s - going to need a new one at some point given the way I ride...lol. Sorry for de-railing the thread |
#28
|
||||
|
||||
I ordered a p3 bashplate from nz.ex us took 10-12days,not bad I didn't think.put a p3 pipeguard on from new 13 200r.from memory the p3 pipeguard was for the 250?(I think) but fitted fine.good quality but pricey in nz$!liv2day this means they do make one that fits the later 200's....or that my pipe is a 250 pipe?
__________________
2013 ec200r |
#29
|
||||
|
||||
P3 did a good job on my bike.
Last ride was only in 1st picking through a rock garden and misplaced the front wheel right into a big pointy one. In hindsight should have throttled over it, but I was trying to stop prior to impact. Ended up balancing the bike, dead stopped by the rock into the base of the pipe after the front rolled over. Bent the pipe at the header a bit. Bent both mounting tabs. Small dent on the seam below the pipe guard. Bit of massage and she's mounted up nice and straight again, ready for the next battle. |
#30
|
||||
|
||||
Quote:
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
P3carbon fiber pipe guard Gas Gas stock pipe 08-11 | REVERUP | Enduro Product Reviews | 28 | 12-30-2013 09:05 PM |
Valley HS July 18, Jack Pine July 25 - Sweet in the Heat | twowheels | Mid-West Forum | 3 | 08-06-2010 11:37 PM |