|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
premix
Was filling the bike up today with the jerry can that i had full of fuel (5L) was putting my silkolene premix stuff into it when my mate said hang on
My mate said im doing it all wrong im premixing to much with the 5L fuel i was putting in 5L fuel + 100ML silkolene premix, Correct? I was also told this was the correct level of mixing from the guy i got the bike from. Could someone confirm that im correct? |
#2
|
||||
|
||||
That would be 50 to 1 or 2% so you're doing it right.
|
#3
|
||||
|
||||
gasser's spot on, heres a calculator you and your buds can use if needed.
http://www.csgnetwork.com/oilfuelcalc.html Ron |
#4
|
|||
|
|||
Everyone run 50:1 here?
__________________
2003 EC250 w/ Ohlins pkg Sometimes you eat the bear, sometimes the bear eats you. |
#5
|
|||
|
|||
When I bought my LTR jet kit Les advised me to run 32:1. Against his advice I have ran 40:1 since the bike was new. Same in the kids bike.
__________________
jeff '00 XC250 (mine) LTS front and rear suspension, power valve cover, carb jet kit and rear chain glide, RB Designs head mod, BRP tall triple clamp, backyard foot-peg lowering conversion. '04 EC250 (the kids) (he can do his own mods haha!) |
#6
|
|||
|
|||
I run 45:1. Used to run 40:1 which always left a small amount of spooge at the end of the silencer. 45:1 has always left my silencer clean.
|
#7
|
||||
|
||||
__________________
2004 GasGas DE250 |
#8
|
|||
|
|||
I run 38:1.
Why? More oil = better ring sealing and less wear. My 2 data points... Top ring end gap increased 0.006" in 91 hours at 50:1 Top ring end gap increased 0.001" in 49 hours at 38:1 This data was with AmsOil Interceptor. Your mileage may vary.
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
#9
|
|||
|
|||
I am running 40:1 outta habit, I am gonna back off to 45:1 and see if that helps spooge.
__________________
2003 EC250 w/ Ohlins pkg Sometimes you eat the bear, sometimes the bear eats you. |
#10
|
||||
|
||||
Quote:
http://www.gasgasrider.org/forum/showthread.php?t=182 It lists the amount of gas in first columns, then the amount of oil in the last columns. 5 liters is approx. 1.25 gallons... so 100 milliliters is right as mentioned previously. The link above gives premix for a variety of ratios.
__________________
Matt Current: 2009 Yamaha FZ1 Previous: 2001 GasGas TXT280, 2001 GasGas XC250, 2004 KTM 200EXC, 2007 GasGas EC250, 2007 Husqvarna SM610, 2008 Husqvarna WB165 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FAQ: Premix Calculations | MattR | Enduro Intake/Carburetion - 2 stroke | 20 | 02-11-2019 01:30 PM |
what ratio to premix at? | j@y | Enduro Engine - 2 stroke | 16 | 05-18-2007 09:53 AM |
premix ratio for 300 two-stroke | gateman | Enduro Engine - 2 stroke | 3 | 09-27-2006 06:29 PM |