|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#11
05-20-2016, 04:50 PM
|
|||
|
|||
Get a set of reverse drill bits and drill into the stud. Use a wrench as backup. Best case scenario, the drill bit turns the stud and your nut backs off. Second best case is you use an EZ out in your newly drilled stud to back the nut off.
Last edited by GGRider01; 05-20-2016 at 06:07 PM. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| More ec 200 problems | gump147 | Enduro Engine - 2 stroke | 9 | 06-01-2015 03:15 PM |
| Wanted!! Ec200 seat, radiators, switch gear, gear lever | Kendog | "Wanted to Buy" & "Want To Trade" | 2 | 10-12-2014 03:12 PM |
| yet more problems | bonkeye | Enduro Electrical & Wiring | 9 | 08-17-2013 09:48 AM |
| Gear problems... | jonnyweston | Enduro Engine - 2 stroke | 3 | 01-04-2008 05:55 AM |
| 06' ec 200 problems | speed addic | Enduro Engine - 2 stroke | 0 | 02-25-2007 06:44 PM |
Threaded Mode