|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
|
Thread Tools | Display Modes |
|
#1
10-24-2011, 11:15 AM
|
|||
|
|||
Stable idle?
Is it the holy grail of 2T jetting? I just tried a #8 slide thinking it would help clean up the off idle jetting compared to the stock 6.5 slide. I couldn't notice any real difference except that it was much harder to get the bike to idle. I think this was a reslut of the new #8 not having a notch.
The 6.5 has a notch that measures .095 wide x .040 deep. This would allow the slide to be closed further (less pullover). Current jetting is 40P, AS 1.5, JD Red #4, 175 main. I rarely ever exceed 1/3 - 1/2 throttle when riding. The AS is not particularily effective. The bike will idle OK for about 20 seconds, then the RPM drops and it flames out. As long as I blip the throttle once in a while it's OK. I don't usually idle for more than 15 seconds when riding. Does this behaviour suggest a low float level?
__________________
2011 EC250E Last edited by Neil E.; 10-24-2011 at 11:54 AM. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Added another GasGas to the stable | fire1998 | General Discussions & Announcements | 5 | 10-05-2011 10:03 PM |
| Bad idle | Madhead | Enduro Intake/Carburetion - 2 stroke | 1 | 08-11-2011 06:20 AM |
| Looking for a Dual sport to add to the stable. Help needed | firffighter | General Discussions & Announcements | 19 | 08-10-2011 03:59 PM |
| can,t get idle up | geno | Enduro Intake/Carburetion - 2 stroke | 1 | 04-18-2010 08:49 PM |
| Adding another gasser to my stable | joey11 | General Discussions & Announcements | 0 | 05-15-2008 12:11 PM |
Threaded Mode