|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#3
|
||||
|
||||
What needle are you using ?
Try a different premix oil, with a lower flash point (like a semi synthetic one). Use full synthetic only if you run the bike pinned most of the time. That should deal with the spooge/wet plug a little bit, but it will not fix the jetting issue. For jetting/needle/spark plug, I'd recommend you go back to "standard" and take it from there (most of us around here run 175/40). The problem may very well be somewhere else. If you are running so lean for me it means you are trying to cover up a different issue with the bike that's causing it to run rich. First thing that comes to mind regarding this is it's sucking gear oil thru the crankshaft seal ?? or the float height may need to be re-adjusted ?? Something definitely wrong tough.
__________________
'14 EC300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gas Gas oil filler plug with 13mm wrench head | Buddmatto | Parts | 5 | 02-01-2018 08:24 AM |
Setting Squish on an off centred plug hole head | savage sausage | Enduro Engine - 2 stroke | 8 | 08-11-2016 12:30 AM |
Swopping 1997 Cylinder head with 2005 head | EC250 | Enduro Engine - 2 stroke | 10 | 12-15-2015 10:13 AM |
Coolant leaking through cylinder head socket-head bolts. | GGRider01 | Enduro Engine - 2 stroke | 5 | 10-17-2015 07:38 PM |
Magnetic hex head oil drain plug crossover?? | eaze_50 | Enduro Engine - 2 stroke | 26 | 05-13-2014 07:08 AM |