|
|
|||||||
| General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
|
Thread Tools | Display Modes |
|
#1
01-26-2012, 10:26 PM
|
|||
|
|||
2011 EStart EC300 Gasket Adjustment Kit
I just received a recall gasket kit for my estart. The starter would only engage 50% of the time. Has anyone installed this kit? It comes with three gaskets. Do you just measure the distance from the case to the end of the flywheel teeth? The instructions show a range of distance as follows
 I assume this is in millimeters as the instructions don't specify the measurement unit and the gaskets aren't numbered.)1. X < 35.7 use 1 gasket ME250544004-3 2. 35.7 < X < 36 use 1 gasket ME250544004 3. 36 < X < 36.3 use gasket ME250544004-8 4. X > 36.3 use 2 gaskets ME250544004-8 and ME250544004-3. My gap is 20MM, so I need to install the thinest gasket in the set(ME250544004-3)? Is that correct?
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Estart - Wet stator conversion | Keg | Enduro Engine - 2 stroke | 11 | 02-21-2014 11:50 AM |
| Estart setup | Neil E. | Enduro Electrical & Wiring | 5 | 06-26-2011 04:25 PM |
| 2005 to 2011 estart conversion | forgiven | Enduro Chassis & Body | 1 | 01-17-2011 07:34 PM |
| A Shout out to eStart | twowheels | General Discussions & Announcements | 5 | 04-19-2010 07:34 AM |
Threaded Mode