|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Help! fitting FSE400 engine in kart, do you hav one?
Hey,
Im fitting an '02 400FSE engine into a kart and need some help, please let me know if you have one of these bikes and could provide an insight. Injected engine, sitting in a cradle with loom all plugged in and battery attached, there is one 2 pin plus that i think is stopping it from running. The two wires are Purple and White w Green trace, These both go to the ecu thats why i assume its stopping it, if any one could let me know where this goes or provide some photos of there wiring i would very much appreciate it. Cheers Joseph (New Zealand) |
#2
|
|||
|
|||
http://www.gasgasmotos.es/en/previous-models.html
just incase any one else is looking, i found a diagram for a similar model on here. cheers |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fitting Clarke 3.2 tank to a '03 ec250 | flybars | Enduro Chassis & Body | 2 | 04-11-2010 04:57 PM |
Fitting 05-06 clarke tanks on '07 FSR450 | gun | General Discussions & Announcements | 4 | 06-05-2009 03:39 AM |
FSE400 throttle tube | nitroman | Enduro Chassis & Body | 0 | 12-22-2007 05:17 AM |
fitting KTM rear wheel to Gasser | moto520 | Enduro Chassis & Body | 3 | 03-19-2007 07:42 PM |
Fse400-02 plastic | raggamuffin | Enduro Chassis & Body | 1 | 01-30-2007 02:34 PM |