|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#11
03-08-2012, 08:56 PM
|
||||
|
||||
Haven't read whole thread, just be aware to melt nylock nut before trying to remove that nut that holds the wire linkage in pic. They are only m4 & like to shear off, that is a pain but repairable. I forgot last time.
No shims, just loosen & readjust lever in cases. Becomes obvious when you do it but the thread help with pics. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Low down / tickover issue HELP | stevehipkiss | Enduro Intake/Carburetion - 2 stroke | 9 | 02-14-2011 09:03 AM |
| jetting - idle issue. | stainlesscycle | Enduro Intake/Carburetion - 2 stroke | 7 | 12-30-2009 02:47 AM |
| clutch issue | boostedte37 | General Discussions & Announcements | 2 | 11-09-2009 06:58 PM |
| ec 400 gearbox issue | Paul Somerville | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 09-05-2009 10:17 AM |
| PowerValve Issue- Take A look at this Picture | alexpp | Enduro Engine - 2 stroke | 13 | 04-12-2009 12:13 AM |
Threaded Mode